Nortel Modular ICS 4.0 - Disconnecting One Party

42 / Answering calls
Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01
3. Press the button where the first call is on hold to create a
conference.
Only the person who established the conference can process
the conference by using the procedures described in this
section.
Disconnecting one party
You can disconnect one party from a conference and continue
talking to the other.
On an M7208, M7310 or M7324 telephone:
1. Press the line button of the call that you want to disconnect.
The call that you want to keep is automatically put on hold.
2. Press ® . The call is disconnected.
3. Press the line button of the held call to speak to the
remaining person.
On an M7100 telephone:
1. Press ƒ£‹ , to place one caller on hold. Press
˙ again, to put the caller you want to keep on
hold.
2. Press ® . The call is disconnected.
3. Press ˙ to speak to the remaining party.
Tip - You can create a conference by releasing privacy
on a call. See “Turning Privacy on or off for a call” on page
49.
p0881591.book Page 42 Wednesday, August 19, 1998 6:43 PM