Nortel Modular ICS 4.0 - Adding or Changing User Speed Dial

68 / Time savers for making calls
Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01
Adding or changing User Speed Dial
ƒ•›
To add or change a User Speed Dial number on your
telephone:
1. Press ƒ•› .
2. Enter a two-digit code from 71 to 94 that you want to
associate with a telephone number.
3. To include a line selection for this number, press the line
or intercom button. To select a line pool, press a
programmed line pool button, or press ∆ and
enter a line pool access code. For the M7100 telephone,
you can select only a line pool.
4. Enter the number you want to program.
5. Press ˙ or OK
.
Displays
Continue entering the number you want to
program. You can change the number by
pressing BKSP
or √ . When you are
finished, press ˙ or OK
.
Enter the telephone number you want to
program exactly as if you were dialing it
normally. When you are finished, press
˙ or OK
.
You have entered a code outside the code
range (01-70 for system, 71-94 for personal).
There is no number stored on the speed dial
code you have dialed.
01:9___
CANCL BKSP OK
Enter digits
QUIT OK
Invalid code
No number stored
p0881591.book Page 68 Wednesday, August 19, 1998 6:43 PM