136 / Programming Hunt Groups
Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01
• members of a group
• member position in a group
• what lines are assigned to a group
• how incoming calls are distributed
• how long the system looks for available members
• where a call goes if all members are busy
Note: Videophones should not be programmed as members of
a Hunt Group. Hunt Groups allow one B channel
connection at a time and videophones use two B
channels.
Features affected by Hunt Groups include:
• Call Forward All Calls
• Call Forward No Answer
• Call Forward on Busy
• Group Pickup
• Transfer via Hold
• Priority Call
• Line Redirection
• Page Zones
• Voice Call
Adding or removing members from a group
Modular ICS 4.0 supports 30 groups programmed with up to
40 members per group to a maximum of 600 members system-
wide. For the recommended configuration please refer to the
Modular ICS Installer Guide. Members of the group can be
any Norstar set, CTA 500dm, ISDN terminal, or portables. A
p0881591.book Page 136 Wednesday, August 19, 1998 6:43 PM
To Next Page
Loading...
