Nortel Modular ICS 4.0 - Changing Set Lock Programming for a Telephone; Using an Auxiliary Ringer; Turning the Auxiliary Ringer for a Telephone on or off

Using System features / 179
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
Changing Set Lock programming for a telephone
You need the programming template found at the front of this
guide. See “Getting started with Norstar” on page 1 for more
information.
1. Press ƒ••¤flfl‹›› .
2. Press ¤‹fl›fl (the default System Coordinator
password).
3. Press ≠ at Terminals&Sets and enter the
internal number of the telephone you want to program.
4. Press ≠ .
5. Press ‘ until the display reads Restrictions.
6. Press ≠ twice.
7. Press ‘ until the display reads Set lock.
8. Use CHANGE
to select one of the three options: None,
Partial and Full.
Using an auxiliary ringer
An auxiliary ringer is a separate device that has to be
connected to Norstar.
Turning the auxiliary ringer for a telephone on or off
You need the programming template found at the front of this
guide. See “Getting started with Norstar” on page 1 for more
information.
1. Press ƒ••¤flfl‹›› .
2. Press ¤‹fl›fl (the default System Coordinator
password).
3. Press ≠ at Terminals&Sets.
p0881591.book Page 179 Wednesday, August 19, 1998 6:43 PM