Novation Circuit - Loading and Saving

18
English
Loading and Saving
When you press Play for the rst time after powering on, the Session Circuit will play will be the
last one used when it was powered off. The factory demo described in the previous section was
loaded in to Memory Slot 1.
To load a different Session, you use Sessions View. Press Sessions
18
to open this:
Each pad corresponds to one of the memory slots. The pad’s colour indicates the slot’s status:
• Dim blue – slot is empty
• Bright blue – slot contains either a Session saved by the user* or a factory demo Session
• White – the currently selected Session (only one pad will be white)
* But see paragraph on “Customising Session Colours” on page 19
If you’re still experimenting, you can select a different factory demo to listen to and play around
with. You can jump between saved Sessions while in Play mode.
Sessions loaded when the sequencer is not running will play at the tempo
that was in force when the Session was saved.
Sessions loaded while the sequencer is running will play at the tempo that is currently
set. This means that you can recall different Sessions sequentially with the condence
that the tempo will remain constant.
There’s nothing special about the slots containing factory demo Sessions: you can overwrite
these if you wish.