Novation Circuit - Session Loading Problems; MIDI Parameters

69
English
Session loading problems
Circuit loads the last selected Session when it is powered-up. It is possible that if the power
was interrupted while a session was being saved it may have become corrupted in some way.
This might mean that Circuit ends up in some anomalous state at power on.
Although this is a very unlikely occurrence, we have included a method of turning Circuit on
and forcing it to load a blank Session instead. To do this, hold down both Shift and Clear while
turning Circuit on.
If any Sessions do become corrupted in any way it is always possible to delete them by using
Clear Session (see “Clearing Sessions” on page 65)
MIDI parameters
Circuit has been designed to respond in various ways to external MIDI data. MIDI Note On/Note
Off, Program Change (PGM) and Continuous Controller (CC) messages are all recognised.
Full details of MIDI settings and parameters are available in a separate document:
Circuit Programmer’s Reference Guide, which may be downloaded from
novationmusic.com/downloads.