5 - 32 en-938821/2
5.4.2 Creating and Debugging a Part Programme
5.4.2.1 Access to Edit Mode
The edit mode is used to create or modify a programme as well as to delete or rename it.
All modifications are stored as soon as they are entered.
Requirements
No mode being executed. If a mode is being executed, selection of the edit mode is only taken into account after an
interruptible block.
Actions
Select the Mode softkeys. ☞
MODE
Display of the Mode softkeys at the bottom of the screen:
SINGLE MDI DRYRUN SEARCH EDIT TEST MANUAL HOMEAUTO
Select the edit mode. ☞
EDIT
Display of the edit mode indicator in the status window (See 3.1.3).
Display of the start of the active programme or display of the message "ENTER PROGRAM NUMBER" if there is no
active programme.
5.4.2.2 Creating or Editing a Part Programme
The edit mode is used like a text editor to modify programme blocks.
Since the edit mode only checks word formats and not block syntax or compatibility, all modified programmes must
be tested (See 5.4.2.6).
A part programme should only be modified by someone who has a sufficient grasp of part programming.
Requirements
System in edit mode (See 5.4.2.1).
Actions
Enter the command corresponding to the operation to be performed
(See tables below).
To Next Page
Loading...
