Setting Up the NVIDIA DGX Station
DGX Station DU-08255-001 _v4.6|5
2.2. Removing or Replacing the Packing
Inside the DGX Station
To prevent damage to components inside the DGX Station during transit, a foam packing piece
is packed inside the DGX Station. Before you connect and power on the DGX Station, you must
remove this packing piece from inside the DGX Station. If you are returning the DGX Station
to NVIDIA under a return merchandise authorization (RMA), replace this packing piece before
repacking the DGX Station.
Before you begin, ensure that:
‣
The DGX Station is shut down and powered off.
‣
The power cable, all communications cables, and any peripheral devices such as displays
and keyboards are disconnected from the DGX Station.
1. Push the button on the right side of the DGX Station back panel to release the side panel
on the right of the DGX Station when viewed from the rear.
2. Lift the panel to remove it.