Maintaining and Servicing the NVIDIA DGX Station
DGX Station DU-08255-001 _v4.6|52
On (steady)
The SSD is operational but is idle.
On (blinking)
The SSD is being read from or written to.
Off
The SSD has failed and must be replaced.
3. Replace the side panel of the DGX Station.
a). Align the bottom edge of the side panel with the bottom edge of the DGX Station.
b). Firmly push the panel back into place to re-engage the latches.
If an SSD has failed, you must replace it as explained in Adding or Replacing an SSD.
4.7.4. Adding or Replacing an SSD
If you want to increase the capacity of the DGX Station RAID array, you can add four SSDs to
the empty drive bays in the DGX Station. If an SSD in the DGX Station fails, replace the SSD to
return the system to operation.
CAUTION: The default RAID level of the array in the DGX Station is RAID 0, which does not
provide any redundancy. If a single SSD in the array fails, all data stored on the array is lost. To
prevent the failure of an SSD from causing a loss of data, ensure that any data on the array that
you want to preserve is backed up.
If you are adding SSDs to the DGX Station, ensure that the following prerequisites are met:
‣
Your DGX Station is running one of the following software releases:
‣
DGX OS Desktop 4.4.0 or later
‣
DGX software for Red Hat Enterprise Linux or CentOS EL7-20.02 or later
‣
You obtained them from NVIDIA Enterprise Support.
SSDs obtained from NVIDIA Enterprise Support are qualified for use with the DGX Station
and are supplied with the necessary screws to secure them to their drive trays.
To Next Page
Loading...
Need help?
General
