Maintaining and Servicing the NVIDIA DGX Station
DGX Station DU-08255-001 _v4.6|75
4. Insert the delivery tube of the filling bottle into the open filler cap at the top of the pump.
5. Gently squeeze the filler bottle to dispense the coolant liquid into the pump until the liquid
reaches the Maximum Level in the reservoir.
6. Replace the filler cap at top of the pump and use the Torx T20 Allen wrench to tighten the
cap until it is finger tight.
Do not over tighten the filler cap.
7. Power on the DGX Station and let it run for one minute.
If the pump makes a grinding noise, power off and power on the DGX Station four times.
8. Ensure that the level of the liquid in the cooling system is at the Maximum Level in the
reservoir.
To Next Page
Loading...
Need help?
General
