Scanning 29
Scanning in Hollerith Check mode
The Océ 3050 Microfilm Scanner feeds a card, scans the card and displays the
Hollerith data in the Run-Time Display window. Errors in the Hollerith coding
can be corrected with edit in the Run-Time Display window.
Note: This mode is not useful when the aperture cards are not punched.
Settings in the Control window
Before starting the scanner, you set the scanning controls in the Control
window.
▼ To start a scanning session in Hollerith Check mode:
1 Click the Hollerith Check button in the Running Mode entry box.
2 Select the Hollerith in the Input Size entry box.
3 Select the required Output Mode.
4 If the output mode is set to Print or Print/File, set the Print Control settings as
required.
5 Place the aperture cards in the input hopper.
6 Click the Start button to start the scanning session.
7 If required, set the names for image files and log file (see figures 9 and 10 on
page 22).
The system switches to the Run-Time Display window (see figure 12 on
page 30).
To Next Page
Loading...
