Introduction 19
Restore the factory default settings
Introduction
Task for: key operator, system administrator
Océ defines the default settings of the Océ VarioPrint 2090. These settings are
the factory default settings. Examples of factory default settings are the default
PostScript settings for the system administrator or the energy save settings for
the key operator.
You can adapt the factory settings, according to your company or department
requirements.
These changed settings are the company settings.
Use this procedure to change the settings back to the factory defaults for the
key operator and for the system administrator. (System administrator mode
includes all network settings)
When to do
Use these options to restore the factory defaults for the key operator or the
system administrator of the Océ VarioPrint 2090 copier/printer.
Before you begin
Start the Océ VarioPrint 2090 Settings Editor in your web browser in key
operator mode or system administrator mode (see ‘Access the Océ VarioPrint
2090 Settings Editor in key operator mode’ on page 9) or (see ‘Access the Océ
VarioPrint 2090 Settings Editor in system administrator mode’ on page 12).
Note: A restart of the Océ Smart Imager is required to apply the new settings.
Note: If you restore the network default settings, you change the initial network
settings. You might not be able to reach the Océ VarioPrint 2090 with these new
settings after a restart of the Océ Smart Imager.
Attention: Remember that after you install the factory defaults back to your
Océ VarioPrint 2090 copier/printer, you loose ALL the previous
copier/printer settings.
To Next Page
Loading...
