Oce VarioPrint 2090 - Set the Default Paper Tray

System configuration 51
Set the default paper tray
Introduction
Task for: key operator
When in a job on the system no paper tray is indicated, the system uses the
default paper tray. You can define this default paper tray in the Océ VarioPrint
2090 Settings Editor.
The system will for default search in the following order:
■ the lowest tray that contains normal A4
■ the lowest tray that contains normal Letter
■ the lowest tray (bulk)
The system gets the list of possible paper trays from the Océ VarioPrint 2090
Settings Editor.
Before you begin
Start the Océ VarioPrint 2090 Settings Editor in your web browser in the key
operator mode (see ‘Access the Océ VarioPrint 2090 Settings Editor in key
operator mode’ on page 9).
How to set the default paper tray
1
Select 'Printer' in the title bar of the Océ VarioPrint 2090 Settings Editor.
2 Click 'Default paper tray'.
3 Select the paper tray to use for default.
4 Click the 'OK' button to apply the changes.