Oce VarioPrint 2090 - Job Queue Management; Allow Automatic Printing

62 Océ VarioPrint 2090 Configuration and maintenance manual
Job queue management
Allow automatic printing
Introduction
The 'Stop automatic printing' function enables you to hold automatic print jobs
that are in the job queue. You access the 'Automatic printing' function in the
Océ VarioPrint 2090 Settings Editor.
If you set the queue mode to continue (do not select 'Stop'), the print jobs go to
the job queue of the Océ VarioPrint 2090. The system processes those jobs in
sequence.
In 'Stop' mode, the Océ VarioPrint 2090 continues to receive the print jobs.
The system processes those jobs, but does not print. A counter appears in the
job queue area on the operator panel to display the number of waiting print
jobs.
If you set the 'Stop' mode and a print job is already in the job queue, that job
is not printed either.
You can still make copies, scans and prints from the mailbox when the job
queue is set to the 'Stop' mode.
When to do
You need to copy your jobs with a high priority or you need to do some system
maintenance. Put the Océ VarioPrint 2090 job queue in the 'Stop' mode. The
system is active, but the operator is in control.
Before you begin
Start the Océ VarioPrint 2090 Settings Editor in your web browser in the key
operator mode (see ‘Access the Océ VarioPrint 2090 Settings Editor in key
operator mode’ on page 9).