Oce VarioPrint 2090 - Add the Staples

122 Océ VarioPrint 2090 Configuration and maintenance manual
Add the staples
Introduction
Task for: operator
The finisher module has 2 on-line staplers, which can staple a maximum of 80
sheets of 80 g/m
2
(20 lbs).When 1 or both staplers run out of staples, the Océ
VarioPrint 2090 displays a staple icon on the screen of the operator panel. The
'System monitor 'shows the empty status of the stapler with a graphic
representation .
If the stapler runs empty when you start a job or during a job, a warning
message appears. If a job stops because of a lack of staples, you have the
following choice.
■ Refill the stapler(s).
■ Cancel the job.
■ Continue the job without staples.
Note: The finisher module has an optional off-line stapler, which can staple 70
sheets of 80 g/m
2
.
When to do
When the staples in the staplers are (almost) used, add the staples.