Oce VarioPrint 2090 - Prints Configuration; Set the Default Staple Mode

System configuration 49
Prints configuration
Set the default staple mode
Introduction
When you create a job on the system, you can define to use 1, 2 or no staples.
You can define the default staple mode in the Océ VarioPrint 2090 Settings
Editor.
The operator panel selects this default staple mode for the 'Basic', 'Staple'
setting of a new job. You can change this staple settting for every job.
Before you begin
Start the Océ VarioPrint 2090 Settings Editor in your web browser in the key
operator mode see Access the Océ VarioPrint 2090 Settings Editor.