Oce VarioPrint 2090 - Default Paper Tray Configuration

System configuration 47
Set the default scan mode (1 or 2-sided)
Introduction
Task for: key operator
In the Océ VarioPrint 2090 Settings Editor you can select the default scan
mode. The scan mode can be 1-sided or 2-sided.
You can change this default setting for each job on the operator panel.
The default scan mode is 1-sided. This indicates that the original is scanned
1-sided if you do not change the original setting in the job definition.
Before you begin
Start the Océ VarioPrint 2090 Settings Editor in your web browser in the key
operator mode (see ‘Access the Océ VarioPrint 2090 Settings Editor in key
operator mode’ on page 9).
Illustration
[21] Set t he default scan mode
[21] Set the default scan mode