Oceanic PROPLUS X - 7: LOW PRESS; 1: WATER TYPE

29
PROPLUS X OPERATING MANUAL
© Pelagic, 2016 Doc. No. 12-5655-r01 (8/19/16)
7: LOW PRESS
The Low Pressure Alarm allows you to set an alarm for when you reach a designated end pressure. You may choose from from 300 to
1500 PSI (20 to 105 BAR) in increments of 100 PSI (5 BAR).
NOTE: The Low Pressure Alarm only considers gas 1.
AUDIBLE
DEPTH
EDT
TLBG
DTR
TURN PRESS
LOW PRESS
SET
LOW PRESS ALARM
(<) BACK TO MENU
VALUE
^ - INCREASE
v - DECREASE
> - SAVE
1000 PSI
CONTROLS
increase value
decrease value
to Alarms Set Menu
to save value
AR
%
0
-
GAS 1
AIR
FO2
PO2
-
46
FT
37
NDC
54
TL
%
400
PSI
(v) TO MENU - (>) TO COMPASS
53
EDT
11
GTR
LOW PSI
Low Press Alarm Triggered
SET UTILITIES
Within the Utilities set menu you can customize the following seven operational functions.
UNITS
WATER TYPE
DEEP STOP
ALGORITHM
SAFETY STOP
CONSERVATIVE
SAMPLE RATE
UTILITIES
SET MENU
SEA
(>) TO S ET
BASIS
FOR
DEPTH
VALUES
CONTROLS
scroll up
scroll down
to Main Menu
to set
1: WATER TYPE
The Water Type feature allows you to set SALT or FRESH water environment for accurate depth calculations.
UNITS
WATER TYPE
DEEP STOP
SAFETY STOP
ALGORITHM
CONSERVATIVE
SAMPLE RATE
UTILITIES
WATER TYPE
FRESH
(<) BACK TO MENU
SETTING
^
- TOGGLE
v - TOGGLE
> - SAVE
CONTROLS
toggle setting
toggle setting
to Utilities Set Menu
to save setting