Oceanic PROPLUS X - ON THE SURFACE BEFORE A DIVE; GAUGE MAIN MENU; INITIATING A DIVE

45
PROPLUS X OPERATING MANUAL
© Pelagic, 2016 Doc. No. 12-5655-r01 (8/19/16)
ON THE SURFACE BEFORE A DIVE
Gauge Surface Main is nearly identical to Dive Mode. Unlike Dive Mode, there will be no Tissue Loading Bar Graph or gas mix values displayed.
CONTROLS
to Main Menu
to Home Menu
to Compass
SURF
0 26
GAUGE
74°F
12:36
PM
70%
3000
PSI
(v) TO M ENU - (>) TO CO MPASS
0
DIVE
--
GTR
:
GAUGE MAIN MENU
To view dive or change settings you must navigate through the Gauge Main Menu.
NOTE: Menu options are similar to those described previously for Norm Mode. See the Norm Surface Mode chapter for further
details.
SET BRIGHTNESS
LAST DIVE DATA
MORE DATA
SET ALARMS
SET UTILITIES
VIEW PREVIEW
GAUGE
MAIN MENU
FOR
ACCESS
LATEST
DIVE DATA
(>) TO VIEW DATA
CONTROLS
scroll up
scroll down
to Surface Main
to access
INITIATING A DIVE
With the ProPlus X in Gauge Mode, a dive will commence upon descending to 5 ft (1.5 m) for longer than 5 seconds. Below is a diagram to help
you navigate Gauge Dive Mode functions. The dive will end and revert to Surface Mode upon ascent to 0.9 m (3 ft) of depth for at least 1 second.
CONTROLS
to acknowledge alarm
to reset timer
to Main Menu
to start/stop timer
to apply Earmark
to Compass
AR
%
11
64
FT
23
RUN
GAUGE
74°F
12:36
PM
70%
1460
PSI
(v) TO MENU - (> ) TO COMPASS
47
EDT
23
GTR
depth
gas pressure
run timer
ascent rate
gas time remaining (0 - 99 min)
elapsed dive time (0 - 599 min)
gas pressure
Bluetooth on
dive #
surface interval