Oceanic PROPLUS X - 2: UNITS; 3: DEEP STOP; 4: SAFETY STOP

30
PROPLUS X OPERATING MANUAL
© Pelagic, 2016 Doc. No. 12-5655-r01 (8/19/16)
2: UNITS
The Units feature allows you to select whether Imperial (FT, PSI) or Metric (M, BAR) units of measure will be displayed.
UNITS
WATER TYPE
DEEP STOP
SAFETY STOP
ALGORITHM
CONSERVATIVE
SAMPLE RATE
SET
UNITS OF MEASURE
(>) BACK TO MENU
SETTING
^
- TOGGLE
v - TOGGLE
> - SAVE
M, BAR
(METRIC)
CONTROLS
toggle setting
toggle setting
to Utilities Set Menu
to save setting
3: DEEP STOP
The Deep Stop feature can be set ON or OFF.
UNITS
WATER TYPE
DEEP STOP
SAFETY STOP
ALGORITHM
CONSERVATIVE
SAMPLE RATE
DEEP STOP
SET
(<) B ACK TO MENU
SETTING
^ - TOGGLE
v - TOGGLE
ON
> - SAVE
CONTROLS
toggle setting
toggle setting
to Utilities Set Menu
to save setting
4: SAFETY STOP
The Safety Stop feature can be set ON or OFF. If SET is selected, you may choose from an available 3 or 5 min Safety Stop at depths of
10, 15, or 20 ft or (3, 4, 5, or 6 m).
UNITS
WATER TYPE
DEEP STOP
ALGORITHM
SAFETY STOP
CONSERVATIVE
SAMPLE RATE
SET
SAFETY STOP
3 min
15 FT
VALUE
(TIME, DEPTH)
^ - INCREASE
v - DECREASE
> - SAVE
(<) B ACK TO MENU
CONTROLS
increase value
decrease value
to Utilities Set Menu
to save value