Oceanic PROPLUS X - WARNING DURING DECOMPRESSION; ALARM DURING DECO; ALARM ON SURFACE

43
PROPLUS X OPERATING MANUAL
© Pelagic, 2016 Doc. No. 12-5655-r01 (8/19/16)
WARNING DURING DECOMPRESSION
When O2 SAT reaches the Warning Level, the audible alarm sounds and the O2 SAT value will ash in the middle of the screen. When the
audible alarm is silenced, the O2 Sat value will alternate with Decoo Stop/Time.
AR
%
20
GAS 1
32%
FO2
PO2
1.20
75
FT
100
TL
%
1024
PSI
(v) TO M ENU - (> ) TO COMPASS
19
GTR
WARNING
02SAT = 80%
AR
%
0
GAS 1
32%
FO2
PO2
1.40
75
FT
100
TL
%
1003
PSI
(v) TO MENU - (>) TO COMPASS
19
GTR
ALARM
GO UP

O2 = 100%

ALARM DURING DECO
If O2 SAT reaches the Alarm level, the audible alarm sounds and the O2 SAT value will ash in the middle of the screen. When the au-
dible alarm is silenced, the message O2 SAT 100% will display solid until on the surface.
GAS 1
36%
FO2
PO2
1.40
SURF
:
0 07
100
TL
%
1067
PSI
(v) TO MENU - (>) TO COMPASS
--
GTR
ALARM
O2 = 100%
ALARM ON SURFACE
• If O2 SAT is 100% upon surfacing while in No Decompression, O2 SAT = 100% will ash until the O2 SAT value decreases below
100%.
• If O2 SAT becomes less than100% during the rst 5 min on the surface, the Delayed Violation 1 Main screen will be displayed.
• If O2 SAT is still 100% after 5 min, operation is to revert to Violation Gauge Mode for 24 hours.