Fuser 110V/220V Mismatch Error
Error Codes that Apply
179
1. Cycle the printer's power.
2. If the problem persists follow the procedure below.
1. Fuser
2. Engine Control Board
Steps Action Taken Yes No
1
Ensure the proper Fuser (110v vs.
220v) is installed in the printer.
Is the correct Fuser installed?
Replace the Engine
Control Board
Replace the Fuser.
Initial Troubleshooting Actions to Take
Parts of the Printer that Apply
Troubleshooting Procedure
To Next Page
Loading...
Need help?
General
