Fuse Cut Error (Fuser)
Error Codes that Apply
155
1. Cycle the printer's power.
2. If the problem persists follow the procedure below.
1. Fuser
2. Engine Control Board
Steps Action Taken Yes No
1
Test the Fuser fuse.
Is the Fuse Cut?
Replace the Engine
Control Board
Go to Step 2.
2
Replace the Fuser. Cycle the power.
Does the error persist?
Go to Step 3.
Complete.
3
Check all pins of the harness between
the Fuser and Engine Control Board.
Replace Engine
Control Board
Replace the Harness.
Initial Troubleshooting Actions to Take
Parts of the Printer that Apply
Troubleshooting Procedure
To Next Page
Loading...
