Fuse Cut Error (Transfer Belt Unit)
Error Codes that Apply
154
1. Cycle the printer's power.
2. If the problem persists follow the procedure below.
1. Transfer Unit
2. HVPS Cover
3. HVPS
4. Engine Control Board
Steps Action Taken Yes No
1
Test the condition of the fuse.
Is the Fuse cut?
Replace the Engine
Control Board
Go to Step 2.
2
Check the connections between HVPS,
HVPS Cover, and Transfer Unit.
Are the contacts clean and intact?
Install a new
Transfer Unit and
verify the fuse blows.
Clean or align contacts
as needed. If the
error persists, go to
Step 3.
3
Does the error persist?
Replace in the
following order:
HVPS Cover
HVPS
Complete
Initial Troubleshooting Actions to Take
Parts of the Printer that Apply
Troubleshooting Procedure
To Next Page
Loading...
Need help?
General
