Unsupported ROM
Error Codes that Apply
111 Duplex Unit 112 Tray 2 Unit 113 Tray 3 Unit
114 Tray 4 Unit 116 Finisher Unit 117 Inverter Unit
1. Reseat the Unit in Question
2. Cycle the Printers Power
3. If the problem persists follow the procedure below.
1. Unit indicated by the Code
2. Engine Control Board
Steps Action Taken Yes No
1
Check for evidence of fault or damage
to the indicated unit.
Is there damage evident?
Replace any damaged
parts
Go to step 2.
2
Go to Step 3.
3
Replace the Engine
Control Board
Replace the indicated
Unit
Initial Troubleshooting Actions to Take
Parts of the Printer that Apply
Troubleshooting Procedure
Check that the Unit is correctly
installed and fully seated.
Reseat the Unit
Check the Unit version using
the Configuration Sheet.
Is the version current?
To Next Page
Loading...
Need help?
General
