Troubleshooting
- 332 -
Non Recommended Color Name
Image Drum
Please See HELP For Details
684, 685, 686, 687,
690, 691, 692, 693,
700, 701, 702, 703,
704, 705, 706, 707
The image drum of the displayed color is not optimal for this
machine. It is recommended to use the image drum that is
optimal for this machine.
684, 690, 700, 704: Yellow;
685, 691, 701, 705: Magenta;
686, 692, 702, 706: Cyan;
687, 693, 703, 707: Black
Caution: Non-
detected. Check User's Manual
"Trouble Shooting" to restore
machine operation
709 You can use any consumables/maintenance parts, but the print
quality may be lowered and the optimum performance may not
be obtained.
If the use of non-genuine consumables/maintenance parts
causes damage to the product or results in your product not
functioning to its full specification, such damage or effects on
the product are not covered by warranty.
When you understand the above points and use non-genuine
consumables/maintenance parts, follow the procedure below.
Power off the main unit.
Power on this machine while pressing «CANCEL» on the
operator panel.
When [Ready To Print] appears, release «CANCEL».
The above operation will be recorded inside this machine.
Error While Initializing Settings
Press OK To Hide This Message
751 The initial value set with the NFC Setting Tool is not properly
reflected in the device settings. Please check a setting value.
Power Off and Wait for a while.
126:Condensing Error
Fatal 126 Condensation has occurred inside this machine.
Turn off the power, and then turn the power back on after a
while.
If the same error message is displayed, contact your dealer.
Recovered from the error nnn
Print again if the printing result
does not come as expected
Press OK To Hide This Message
- An error has occurred inside this machine, and the machine has
restarted. Check that the print result comes as expected, since
the machine may restart during printing.
Print again if the printing result does not come as expected.
Service Call
- An error has occurred inside this machine.
Please contact your dealer.
Communication Error - An error has occurred in this machine. Restart this machine.
If the error persists, contact your dealer.
Detected An Abnormality Of
Internal Database
The Data Must Be Deleted
After Pressing [OK], The Data Will
Be Deleted, And Then Reboot
- An error has occurred in the internal database of this machine.
Press «OK» on the operator panel to delete the database and
restart this machine.
Language Change Failed. Error
- Failed to change the display language on the display.
Restart this machine, and reset the language setting.
Firmware Update Error. Perform
Firmware Update Again
If The Same Error Message
Appears, Please Contact Our
- Firmware update has failed.
Please update the firmware again. For details, see "Firmware
update(P.324)".
PU Flash Error - An error has occurred in this machine.
Please contact your dealer.
Memory Is Not Enough. Please
Reduce Resolution Or Finish The
Function
Press OK To Hide This Message
- The memory is insufficient.
Print again after lowering the printing quality in the printer driver.
To Next Page
Loading...
