Oki ES6450 - The Color of Images Does Not Come as Expected; An Afterimage Printed on the Front Edge of the Paper Is Printed

Troubleshooting
- 373 -
The color of images does not come as expected
Cause
Solution
Reference
The toner is low. When "Toner Low." or "Toner Empty. Replace with a new
toner cartridge." is displayed, replace the toner cartridge.
Replacing the
black(K) toner
cartridge and the
waste toner
box(P.298)
The setting of [Black Finish] is not
suitable for the application.
In [Black Finish] of the printer driver, select [Composite
Black (CMYK)] or [True Black (K)].
Screens and
functions of the
printer
driver(P.133)
Color tuning has been changed. Perform color matching in the printer driver.
Color matching in
the printer
driver(P.168)
Simulating print
results(P.169)
Color balance is not adjusted. Press the scroll buttons on the operator panel several times
to select [Calibration], adjust density, or adjust the color
balance.
Adjusting th
e
density
manually(P.171)
Adjusting the
color balance
(density)(P.171)
Color misregistration is not
corrected.
Open and close the front cover. Or, press the scroll buttons
on the operator panel several times to select [Calibration] -
[Adjust Registration].
Adjusting
registration
manually(P.170)
An afterimage printed on the front edge of the paper is printed
Cause
Solution
Reference
If an afterimage is printed under
about 94 mm, the media weight
may not be set correctly.
Press the scroll buttons on the operator panel several times
to select the paper tray you are using from [Menus] - [Tray
Configuration], and set an appropriate value for [Media
Weight]. Or, change [Media Weight] to a thinner value than
the present value.
Setting paper
information on the
operator
panel(P.81)
If an afterimage is printed at an
interval of about 94 mm, the fuser
unit may be scratched or dirty.
Replace the fuser unit.
Replacing the
fuser unit(P.310)