Troubleshooting
- 341 -
2
Pull the front cover open lever (blue) to open the front cover.
3
Pull the L2 lever and lift the output tray until it reaches the stop position.
4
Remove the paper left on the belt unit if any.
Doing so may cause burns.
Do not touch the fuser unit because it is hot.
Because image drums (green parts) can easily get damaged, handle with adequate care.
Do not expose the image drum to direct sunlight or strong light (About 1,500 lux or above). Do not leave it
uncovered for more than 5 minutes even under room lighting.
5
Lift the belt unit up by holding its handle.
To Next Page
Loading...
