Microline 8810 User’s Guide
54
Cont. I-Prime
Sets what happens when an I-Prime signal is received. To
prevent any movement of the printhead when an I-Prime signal
is received, change the setting to Invalid.
CSF Select
Applies only when two optional CSFs are installed.
Determines which CSF (front or rear) is used/selected first.
CutSheet Smooth
Helps to correct for paper curl when feeding in a form manually
through the platform. Available settings: Valid [the default] or
Invalid.
Data Word
ML emulation only.
Sets the character code and graphics data for 8Bits [the default]
or 7 Bits.
Diagnostic Test
Applies only when the optional RS-232C Serial Interface is
installed.
To run the diagnostic test, enter the menu and select Yes.
DRAFT Mode
Choose HSD (High Speed Draft) [the default] or SSD (Super
Speed Draft).
DSR Signal
Applies only when the optional RS-232C Serial Interface is
installed.
Sets the way your system handles the DSR signal when the
Ready/Busy protocol (the default) is engaged. Change the
setting to Invalid if you want the printer to ignore the DSR
signal.
DTR Signal
Applies only when the optional RS-232C Serial Interface is
installed.
To Next Page
Loading...
