Oki MICROLINE 8810 - Tests; Rolling ASCII Test; Font Sample Test

Microline 8810 User’s Guide
76
Tests
Rolling ASCII Test
Note When the printer is running a test, it always uses a left margin of 5.1
mm (0.2-inch).
This test provides a one-page continuous printout of the ASCII characters.
1. Turn off the printer.
2. Simultaneously press and hold the LF and FF switches while turning on
the printer, until RELEASE SW displays.
3. When prompted, load a sheet of paper on the platform.
4. The Rolling ASCII test will run and the sheet will eject.
Font Sample Test
Note When the printer is running a test, it always uses a left margin of 5.1
mm (0.2-inch).
This test provides a sample of each of the available fonts in the printer.
Note The Font Sample test takes two letter-size sheets.
1. Turn off the printer.
2. Simultaneously press and hold the MODE and LF switches while turning
on the printer, until RELEASE SW displays.
3. When prompted, load a sheet of paper on the platform.
4. The Font Sample test will run and the sheet will eject.
5. Remove the first printed sheet from the platform and load another
sheet.
6. The test finishes printing and the sheet ejects.