Microline 8810 User’s Guide
81
5. Press FF repeatedly until
GAP CONTROL displays.
6. Press MODE repeatedly until the desired printhead gap setting appears
on the display.
7. Press and hold SHIFT, then press FF repeatedly until
FRONT FEED
displays.
8. Press FF repeatedly until
GAP CONTROL displays.
9. Press MODE repeatedly until the desired printhead gap setting appears
on the display.
Note To set the gap for the optional CSF and/or the optional Rear
Push Tractor, repeat steps 7-9 for CSF FRONT, CSF REAR,
and/or
REAR FEED.
10. Press LOAD: this saves your setting and exits the menu mode.
To Next Page
Loading...
