Oki MPS5502 - Page 341

45641001TH Rev.1
11-43 /
Oki Data CONFIDENTIAL
05/
08
Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proce-
dure
08 Setting
Mode
System User
interface
8745 Enable/Disable
settingofEWB
history
0 0-1 SYS Setswhetherpartofthecookie,password,andformdata
ofuserwhologsintoEWBissavedornot.
0: Disabled
1: Enabled
1
08 Setting
Mode
System Network 8746 Port number
setting of
destination 10 for
sending trap
162 1-65535 NIC Sets the port number of destination 10 for sending SNMP
trap. If the port is used when using the real time log
noticationfunction,changetheportnumber.
12
08 Setting
Mode
System User
interface
8748 Input of
department code at
user authentication
0 0-1 SYS 0:Notrequired
1:Required
1
08 Setting
Mode
System Network 8749 User authentication
by logon
information to
domain (external
authentication)
0 0-1 SYS 0: Disabled
1: Enabled
1
08 Setting
Mode
System General 8750 Time to wait for
print image
0 0-1 SYS Sets whether the drum idling is executed or not when the
waiting for print image occurred. If there is the stain on
thebacksideofthepaper,setthevalueofthiscodeto
“1”.Whenthevalueissetto“1”,thenumberoftimesthe
equipmentstopsprintingmayincrease.
0:Waitingisenabled(8sec.)
1:Waitingisdisabled(0sec.)
1
08 Setting
Mode
System
Maintenance Notification of
remaining amount
of toner
8755 Enable/Disable
setting
0 0-1 SYS 0: Disabled
1: Enabled
1
08 Setting
Mode
System
Maintenance Notification of
remaining amount
of toner
8756 0 Remaining amount
at first notification
25 0-100 SYS 0 to 100% 4
08 Setting
Mode
System
Maintenance Notification of
remaining amount
of toner
8756 1 Notification interval 10 1-25 SYS 1 to 25% 4
08 Setting
Mode
System User
interface
Card reading
device
8758 Overwriting of login
at authentication
0 0-1 SYS Switches the enable/disable setting for the function to
overwrite the login information at the card authentication.
0: Disabled
1: Enabled
1
08 Setting
Mode
System General 8761 Retention of print
(spooling) data
0 0-1 SYS Use this code to retain and obtain the print data (spooling
data)ifproblemoccurs.Afterobtainingthedata,besure
to disable the setting.
0: Disabled (print data is deleted)
1: Enabled (print data is retained)
1
08 Setting
Mode
System
Maintenance Display of
remaining life (for
RDMS/MMDT)
Toner 8762 0 K 0 0-100 SYS 0
~
100%. The small value indicates that the remaining
life is short.
14