12. SERVICE MODE Field Service Ver. 2.0 Jul. 2009
612
ADJUSTMENT / SETTING
12.16.18 FS-FN adjustment - Side position adjustment
A. Use
• To fine adjust the horizontal width of the aligning plate.
• Use this feature to fine adjust the aligning plate that aligns ejected paper.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] o [FS-FN adjustment] o [Side position adjustment].
3. Select a mode from the following.
The default setting is “0.0mm”.
Adjustment range: -10.0 mm to +10.0 mm (1 step: 0.1 mm)
4. Set and adjust a value with the [+]/[-] key.
5. Press the Reset key.
6. Touch [Exit] on the Service Mode screen.
7. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
12.16.19 FS-FN adjustment - Punch unit edge detection
A. Use
• To adjust sensitivity (intensity) of the paper size detect board (PSDTB) of the punch unit
of ZU.
• Make the adjustment upon setup of ZU.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] o [FS-FN adj
ustment] o [Punch unit edge detection].
3. Press the Start key.
4. Check that [OK] is displayed.
NOTE
• If the [NG] appears, check the install condition again.
5. Touch [OK] twice.
6. Touch [Exit] on the Service Mode screen.
7. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
Service Manual Y110571-1
To Next Page
Loading...
Need help?
General