12. SERVICE MODE Field Service Ver. 2.0 Jul. 2009
536
ADJUSTMENT / SETTING
12.9.11 Line Mag Setting
• This feature is not available in this machine.
12.9.12 Data Capture
A. Use
• When an error occurs, it acquires the print job data in order to analyze the cause of the
error.
• When an error occurs, this will be used to analyze the cause of the error according to the
print job data.
B. Procedure
NOTE
• The following conditions are necessary for this function.
When selecting [Security Setting] o [Security Details] o [Print Data Capture] in
Administrator Settings, [Allow] must be set.
The hard disk must be mounted to the machine.
When selecting [Administrator Settings] o [Network Settings] o [FTP Settings],
[FTP Server Settings: ON] must be set.
• This function is not available when the optional image controller IC-412 is
mounted.
1. Select [Service Mode] o [System 2], and touch [Data Capture]. Select [ON].
(While the Data Capture setting is [ON], the print job data from the PC will be stored in
the hard disk.)
NOTE
• The original offset value can be disabled to address image failure and other prob-
lems caused by individual CCD performance difference.
2. Check the IP address of the machine.
3. Connect the PC (Windows) and the machine with ethernet cable.
4. Start the DOS command prompt of the PC, and specify the IP address of the machine
to start FTP.
A0P0F3E547DA
Service Manual Y110571-1
To Next Page
Loading...
