5-5
Operation on the Machine > Connecting cable
Loading Originals in the Document Processor
The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned.
Originals Supported by the Document Processor
Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed or the
document processor may become dirty.
• Document Processor Originals Not Supported by the Document Processor Originals bound with clips or staples
(Remove the clips or staples and straighten curls, wrinkles or creases before loading. Failure to do so may cause the
originals to jam.)
• Originals with adhesive tape or glue
• Originals with cut-out sections
• Curled original
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.)
• Carbon paper
• Crumpled paper
1
Adjust the original width guides.
Weight 45 to 160 g/m
2
(duplex: 50 to 120 g/m
2
)
Sizes Maximum A3/Ledger (297 x 432 mm) (Long-sized 297 x 1,900 mm) to Minimum A5-R/
Statement-R (140 x 182 mm)
No. of sheets Plain paper (80 g/m
2
), Color paper, Recycled paper, High Quality paper: 50 sheets
• Before loading originals, be sure that there are no originals left on the original eject table. Originals
left on the original eject table may cause the new originals to jam.
• Do not make an impact on the document processor top cover, such as aligning the originals on the
top cover. It may cause an error in the document processor.
To Next Page
Loading...
Need help?
General
