FAX Operation (Advanced)
OPERATION GUIDE 4-27
4
File Format Setting (for Each Requirement)
If you are sending the file as an E-mail attachment or transferring it to a folder (SMB or FTP), select PDF or TIFF
as the file format.
1 Follow steps 1 to 4 of Using Requirements for All
Receptions on page 4-19.
Follow steps 1 to 4 and 14 of Registering Settings
by Requirement on page 4-21.
2 Press [Change] of File Format.
3 Press [PDF] or [TIFF], and then [OK].
NOTE: If you have selected PDF for file format, PDF
Encryption functions are available. For details, refer to
the machine's Operation Guide.
4 Press [OK].
E-mail Subject Add. Info Setting
Specify whether any information will be added to the subject of the E-mail. When adding information, you can
select either Sender Name or Sender.
1 Follow steps 1 to 4 of Using Requirements for All
Receptions on page 4-19.
Follow steps 1 to 4 and 14 of Registering Settings
by Requirement on page 4-21.
2 Press [Change] of E-mail Subject Add. Info..
3 Press [Sender Name], [Sender FAX No./Address]
or [Off] and then press [OK].
FTP Encrypted TX Setting
Specify whether to use FTP encryption when you send data.
1 Follow steps 1 to 4 of Using Requirements for All
Receptions on page 4-19.
Follow steps 1 to 4 of Registering Settings by
Requirement on page 4-21.
2 Press [Change] of FTP Encrypted TX.
3 Press [On] or [Off].
4 Press [OK].
NOTE: To enable FTP Encrypted TX setting, be sure
that SSL of Secure Protocol is On. For details, refer to
the machine's Operation Guide.
To Next Page
