3-29
Sending Faxes > Continuous Scan
Cancelling Delayed Transmissions (Queued)
To cancel delayed transmissions that are queued, use the procedure below.
1
Display the screen.
[Status/Job Cancel] key > [Sending Jobs] > [Scheduled]
2
Canceling a job.
Select the job you want to cancel and select [Cancel] > [OK].
The selected job is deleted.
Immediate transmission
To send delayed transmissions immediately rather than waiting for the specified time, use the procedure below.
1
Display the screen.
[Status/Job Cancel] key > [Sending Jobs] > [Scheduled]
2
Immediate transmission.
Select the job you want to send by immediate transmission, and select [
Start Now
] > [
Start
].
The transmission will start.
Continuous Scan
Scans a large number of originals in separate batches and then produce as one job.
Originals will be scanned continuously until you select [Finish Scan].
You can set the functions that appear on the screen during scanning.
(Value: [Off] / [On])
Job Finish Notice
Sends E-mail notice when a job is complete. It is also available that send a notice when a job is interrupted.
Users can be notified of the completion of a job while working at a remote desk, saving the time spent waiting beside the
machine to finish.
It is possible to attach an image to the e-mail notice.
Job Finish Notice Setting (page 8-7)
When scanning and sending source documents on the platen, you can always set Continuous Scan.
Always Continuous Scan with Platen (page 8-11)
PC should be configured in advance so that E-mail can be used.
Machine’s Operation Guide
E-mail can be sent to a single destination.
To Next Page
Loading...
