Olympus BX53M - Page 36

30
Restoring the stored brightness (LIM function)
to the factory default setting
Set the main switch of the microscope frame to (OFF).
If the control box is combined, remove it.
Set the main switch of the microscope frame to
(ON) while pressing
both the LIM switch
a
and the SET switch
b
. Keep pressing the
LIM switch
a
and the SET switch
b
. After 5 seconds, the stored
brightness returns to the factory default setting.
If you release the LIM switch and the SET switch within
5 seconds, the stored brightness (LIM function) does not
return to the factory default setting and the microscope starts
normally.
Set the main switch of the microscope frame to
(OFF). If the
control box is combined, attach it again.
For procedures to attach the control box, see "Attaching the control
box" (page 100).
1
2
3
TIP
4
a b