Olympus BX53M - Transmitted Light Simple Polarization Observation Procedures

58
4-7 Transmitted light simple polarization observation procedures
Filter mount of the microscope frame (page 50)
Select the light path. (Trinocular tube only)
5
Turn ON the main switch.
1
Light path selection lever of the trinocular
tube (page 19)
Main switch (page 16)
Stage plate (page 19)
X-axis / Y-axis knob of the stage (page 19)
Nosepiece (page 23)
Coarse / Fine focusing knob of the
microscope frame (page 24)
Brightness control knob of the microscope
frame (page 26)
Brightness control knob of the microscope
frame (page 26)
Binocular tube (page 32)
Diopter adjustment ring (page 32)
Condenser height adjustment knob (page 48)
Condenser centering knob (page 48)
Nosepiece (page 23)
Coarse / Fine focusing knob of the
microscope frame (page 24)
Field diaphragm ring of the microscope
frame (page 48)
Place a sample on the stage.
6
Engage the 10X objective in the light path.
7
Bring the sample into focus.
8
Adjust the interpupillary
distance.
Adjust the diopter.
Adjust the optical axis.
10
11
12
Adjust the brightness.
4
Engage the objective with the magnification to be used
in the light path and bring the sample into focus.
14
Adjust the field diaphragm.
13
Insert the required filters.
15
Adjust the brightness.
16
Analyzer insertion slot of the reflected light
illuminator / filter mount of the microscope
frame (page 65)
Set the analyzer and the polarizer.
3
Brightness control knob of the microscope
frame (page 26)
Adjust the brightness.
9
Start observation.
Transmitted/reflected light switch (page 16)
Select the transmitted light illumination
2