105
Record mode
6
Adjusting the image quality and exposure
•
The number of storable still pictures that can be taken may change according to
the subject or factors such as whether print reservations have been made or not.
In certain instances, the number of remaining pictures displayed on the monitor
does not change even when you take pictures or stored images are erased.
•
In some cases, the larger the capacity of the card, the greater the difference
between the calculated number of pictures and the actual number of pictures.
•
If movies are shot with VIDEO OUT set to PAL and the AV cable connected, the
movie recording time will differ from the time listed in the Movie Record Modes table.
Selecting a record mode
1 Turn the control dial while holding down
K to select the record mode.
• The record mode changes in the sequence shown
below.
Still Picture Record Modes
Movie Record Modes
2 If you selected a still picture record mode,
press e while holding down K to display
the screen for selecting the resolution.
3
If you selected TIFF, SHQ or HQ, press
ac
to select a resolution, then press
e
.
If you selected SQ1 or SQ2, press
ac
to
select a resolution, then press
d
. Press
ac
to select HIGH or NORMAL, then
press
e
.
Note
Mode dial
K Record
mode button
Control dial
Arrow pad
OK button
RAW TIFF SHQ
SQ2 SQ1 HQ
RAW
tIFF
SHQ
HQ
SQ1
SEt
SHQHQSQ
HQ
3264 2448
3264
2176
GO
SELECt
25922592 19441944
2288 1712
2048 1536
SQ1
HIGH
NORMAL
GO
SEt
SELECt
When HQ is selected
When SQ1 is selected
To Next Page
Loading...
