168
9
Camera Settings
Setting the date and time
The date/time is saved with recorded pictures and file names are assigned
based on the date/time settings.
1 Select SETUP X, then press d.
g“Menu basics” (P.38)
•Press c repeatedly until X is displayed on the
monitor.
2 Press ac to select one of the following
date formats:
Y-M-D (Year/Month/Day),
M-D-Y (Month/Day/Year),
D-M-Y (Day/Month/Year).
Then press d.
• Move to the year setting.
• The following steps show the procedure used when the date and time settings
are set to Y-M-D.
3 Press ac to set the year, then press d to
move to the month setting.
• To move back to the previous setting, press b.
• The first two digits of the year are fixed.
4 Repeat this procedure until the date and time are completely set.
• The time is displayed in the 24-hour format. For example, 2pm will be
displayed as 14:00.
5 Press e.
• For a more accurate setting, press e when the time signal hits 00 seconds.
• The date and time settings will be returned to the factory default setting if the
camera is left without the battery for a few days. The settings will be
canceled more quickly if the battery was only loaded in the camera for a
short time before being removed. Check that the correct date and time have
been set before shooting.
Mode dial
Arrow pad
OK button
Y M D
SELECt
GO
SEt
200
To Next Page
Loading...
