199
11
Direct printing (PictBridge)
If an error code is displayed
If an error code appears on the camera’s monitor during direct print setting or
printing, see the following table.
For more details, refer to the printer’s instruction manual.
TIPS
• If an error code other than those shown above is displayed, refer to “Error
codes” (P.200).
Monitor indication Possible cause Corrective action
NO CONNECTION
The camera is not
connected to the printer
correctly.
Disconnect the camera and
connect it again correctly.
NO PAPER
There is no paper in the
printer.
Load some paper in the
printer.
NO INK
The printer has run out of
ink.
Replace the ink cartridge in
the printer.
JAMMED
The paper is jammed. Remove the jammed paper.
SETTINGS CHANGED
The printer's paper
cassette has been
removed or the printer has
been manipulated while
making settings on the
camera.
Do not manipulate the
printer while making settings
on the camera.
PRINT ERROR
There is a problem with
the printer and/or camera.
Turn off the camera and
printer. Check the printer
and remedy any problems
before turning the power on
again.
To Next Page
Loading...
