59
4
Flash
4 Flash
Flash shooting
Select the flash mode best suited to the light conditions and the effect you want
to achieve. You can also adjust the amount of light emitted using the flash
intensity control.
1 Press the flash pop-up button ().
• The flash pops up ().
2 Set the flash mode by turning the control
dial while holding down #.
• The flash mode changes in the sequence shown
below. (The selectable flash modes may differ
depending on the shooting mode.)
3 Press the shutter button halfway.
• # lights when the flash is ready to fire.
4 Press the shutter button fully to take the
picture.
Flash working range
W (max.): Approx. 0.8 – 5.8 m (2.6 – 19 ft.)
T (max.): Approx. 0.2 – 4.0 m (0.7 – 13.1 ft.)
Mode dial
Flash pop-up button
Control dial
# Flash mode button
FLASH MODE
AUtO
SLO W
SEt
Auto (Auto-flash)
!
(Red-eye reduction flash)
#
(Fill-in flash)
$
(Flash off)
#
SLOW (Slow synchronization)
3264*2448
To Next Page
Loading...
