137
7
Playback
Recording sound
Sound can be added to a still picture that you have already taken. (This is known
as “after-recording”.) You can also re-record over the sound that has already
been recorded. Total recording time per picture is approximately 4 seconds.
1 Select the still picture to which you want to
add sound, then press e to display the top
menu.
2 Press c to display START.
3 Turn the camera microphone toward the
sound you want to record and press e to
start recording.
•The BUSY bar is displayed during recording.
• If the microphone is placed farther than 1m (3.3ft) away from the subject, the
recorded sound quality may not be satisfying.
• If you re-record the sound, the original sound is erased.
• You may not be able to record sound when there is insufficient card memory
(the CARD FULL message is displayed).
• Sound recording may pick up camera noises, such as button operation or
shutter movement.
• Once sound is added to a picture, it is not possible to erase only the sound.
In this case, make a re-recording with silence.
Mode dial
Arrow pad
OK button
MODE MENU
8
Microphone
Note
To Next Page
Loading...
