22
Inserting a card
1
Getting started
1 Make sure the camera is turned off.
• The monitor is off.
• The viewfinder is off.
• The lens is retracted.
2 Open the card cover.
3 Insert a card.
xD-Picture Card
• Insert the card into the front slot, ensuring that it
is not inserted diagonally.
• Insert the card as far as it will go until it clicks.
• If the card is inserted incorrectly oriented or it is
inserted at an angle, the contact area may be
damaged or the card may become jammed.
• If the card is not inserted fully, it may not be able
to record data.
CompactFlash/Microdrive
• Hold the card straight and insert it correctly into
the rear slot, as shown.
• Set the eject button in the down position.
4 Close the card cover securely until it
clicks.
Removing the card
xD-Picture Card
• Push the card all the way in to unlock it, then let
it return slowly.
The card will be ejected. Take hold of the card
and pull it out.
Card
cover
Notch
Eject button
Releasing your finger quickly after pushing the
card all the way in may cause it to eject forcefully
out of the slot.
Note
To Next Page
Loading...
