Omega DP25B-S - 4.7.2 Selecting if Setpoint 2 is Latched or Unlatched; 4.7.3 Assigning Setpoint 2 Values to Net or Gross Readings

33
Configuring The Meter
4
4.7.2 Selecting if Setpoint 2 is Latched or Unlatched
1. Press the MENU button until S2.CF displays, then press the ∂TARE button twice.
or
Press the ∂TARE button from S.1.
The meter shows one of the following:
• S.2=U Setpoint 2 to be unlatched (Default)
• S.2=L Setpoint 2 to be latched
2. Press the ßNT/GRS button to toggle between available choices.
3. Press the MENU button to store your selection(s). The meter momentarily shows
STRD , followed by S1.DB (Setpoint 1 Deadband).
4.7.3 Assigning Setpoint 2 Values to Net or Gross Readings
1. Press the MENU button until S2.CF displays, then press the ∂TARE button twice.
or
Press the ∂TARE button from S.2.
The meter shows one of the following:
• S.3=N Setpoint 2 assigned to net reading (Default)
• S.3=G Setpoint 2 assigned to gross reading
2. Press the ßNT/GRS button to toggle between available choices.
3. Press the MENU button to store your selection(s). The meter momentarily shows
STRD, followed by S1.DB (Setpoint 1 Deadband).