The options menu allows you to configure the following settings:
General:
Default level unit: allows you to change the unit for Bode 100's
source level setting. You can choose dBm, Vpp or Vrms.
dBm defines the power dissipated into 50 Ω load.
Vpp and Vrms are the voltage output levels present
when a 50 Ω load is connected at the output. Due to
the source's output impedance the output voltage will
change depending on the impedance of the connected
load. See more in 9.4 Signal source settings on
page 80.
Result display digits: Defines the number of digits behind the
decimal separator for values shown in the cursor grid and used for
reporting.
Short trace-name length: This number defines how many letters
are used for the name of a measurement or memory trace in the
cursor grid, report and clipboarding.
Zero rounding limit: Values below this number will be displayed
as zero. This setting applies to Phase (°) and Magnitude dB.
Theme:
Use the Current theme setting to switch between light and dark
theme.
Select your preferred accent color in Current accent.
With the Zoom factoryou can increase the size of the GUI for use
on e.g. high-dpi screens.
Logging:
Log Level:This function allows you to define the severity level of
the events stored in the log-file. Default is Warning.
Do not use the log-levels Verbose or Debug, except if
told by the OMICRON Lab support team.
UDP Logging: allows you to enable event logging via UDP and
to define the used UDP port.
Logging to a file: allows you to enable the logging of events
to a log file and to define the location of the log file on your
computer's hard drive.
Common:
Allows you to enable the device selection in the start up screen
and to change your preference in relation to the Customer
Experience Improvement Program.
32
OMICRON Lab
To Next Page
Loading...
