Calibration / Correction:
You can enable "live update" respectively "recalculate
measurement trace values retroactively". This will recalculate
the measurement trace values whenever a calibration-related
parameter changes. The effect of disabling or enabling a
calibration / correction will immediately be shown on the
measurement result and not only used for new measurements.
You can therefore see the influence of a correction on your results
by enabling/disabling a calibration and watching the result change.
Activate port extension to switch on the Port extension feature.
The icon will be shown in the Home ribbon. For more details,
please refer to Port extension.
Hint: Click to switch back to the default settings of all options at any
time.
Bode Analyzer Suite introduction
OMICRON Lab
35
To Next Page
Loading...
