The sections in this area allow you to optimize the quality and
appearance of the charts displayed in the Bode Analyzer Suite.
General:
Choose if numbers in axis labels are displayed in Engineering
format (e.g. 1e3) or with SI prefixes (e.g. 1k).
Use the default axis placement setting to choose if you prefer
auto-axis placement or only one axis per chart.
Logging:
Further on, you can activate a logger that can be useful to find the
reason for errors in the chart.
Normally you only need this option when told by the OMICRON
Lab support team.
Render Settings:
In case your chart does not show up correctly, please try to
change the Chart render mode. Automatic is default and tries
to use hardware rendering with DX11. In some rare cases with
old graphics cards or problems with the graphics drivers, this can
lead to problems. Try using hardware (DX9) or software rendering
instead.
Software rendering can significantly increase the
processor usage on your system.
General:
Here you can select the maximum number of memory traces,
the default memory line pattern (e.g. solid or dashed) as well as
if the deletion of a memory trace needs to be confirmed or not.
Alternating memory trace color mode:
By enabling this mode you can make it easier to find out to which
trace a memory belongs. If activated each memory alternates the
memory color and the color of the trace it belongs to as shown
below:
34
OMICRON Lab
To Next Page
Loading...
