Further on you can use the cursors to perform measurements. To do so simply drag the cursors to the
point you want to measure (1.) and check out the results in the cursor grid (2.) as shown in 8-4 on
page 49. For more cursor functions visit 11.3 Working with cursors and the cursor table on page 125.
Figure 8-4: Use of cursors and cursor grid
Congratulations you have performed your first measurement with the Bode 100. You can load the
settings for the measurement by clicking File → Open → and then navigating to: "%APPDATA%
\OMICRON Lab\Bode Analyzer Suite\Demo Files\". The file you will need is: TransRefl_IF-
Filter.bode3
Hint: The Transmission / Reflection is the most flexible measurement setup for the
Bode 100. By selecting this setup you can switch between internal and external reference.
Further on, you can switch the input impedance of input CH1 and input CH2 between 50 Ω
and high impedance.
Measurement types and applications
OMICRON Lab
49
To Next Page
